MiniFinder IP1
Guided setup available
Set upload interval (60s)
TI60SAPN commands depend on the carrier SIM in your tracker, so they are not shown here.
14 devices
4 brands
MiniFinder Protocol (!type semicolon ASCII)
MiniFinder on TCP 5062: bang-typed ASCII ending in semicolon; !1 binds IMEI, !A/!C/!D/!B plot, !3/!4/!5 do not.
On Traxelio
What Minifinder trackers do once they are on Traxelio
Hardware that speaks this protocol
Devices that speak Minifinder
Point this protocol at Traxelio
Point Minifinder at Traxelio
-
1
Capture a MiniFinder fingerprint
Confirm a !1,imei bind and a later !A or !D row with dd/mm/yy slash dates, ending with a semicolon.
-
2
Point MiniFinder at 5062
Configure only MiniFinder to TCP 5062. MiniFinder on 5062 is not MiniFinder 2 on 5187 or Xexun on 5006.
-
3
Do not wait for an ACK
MiniFinder has no reply byte. A parsed !A or !D lat/lon pair is enough.
-
4
Prove one MiniFinder fix
Send one !A, !C, !D, or !B line with valid flag bits on 5062 and verify a map point.
gps.traxelio.com:5062
TCP
Still offline after GPS lock
Minifinder still not landing
- MiniFinder aimed at the wrong port
MiniFinder on 5062 is not MiniFinder 2 on 5187 or Xexun on 5006.
- Session up, empty map
!1 binds the IMEI and will not plot. Send !A, !C, !D, or !B with valid flag bits.
- No ACK, assumed dead
This dialect has no reply byte. Check the map, not the socket for an ACK.
FAQ
Minifinder leftover questions
Does MiniFinder send Concox 0x7878 frames?
No. MiniFinder uses bang-typed ASCII rows that end with a semicolon. Concox families use 0x7878 binary login.
What does a MiniFinder !1 row do?
It binds the IMEI for the session and does not plot a point.
Which MiniFinder types plot a fix?
!A, !C, !D, and !B carry lat/lon. !3, !4, and !5 reuse the last point.
What MiniFinder flag bits raise SOS and fall?
Bit 6 is SOS. Bit 8 is fall. Bits 9-11 are geofence. Bit 12 is low battery.
Can a MiniFinder unit run a controlled-action flow?
This dialect is positions only. There is no SMS family on this row.