Server address
Send positions to this server
The plain Carscop CCTR is listed on the H02 protocol, but numbered CCTR variants split across three protocols. Read the full marking on your unit before you set a server.
Data Points
Alerts
Vehicle Types
It depends on the full marking. A public device list shows the plain CCTR, CCTR-630, CCTR-830G and CCTR-622G on H02, CCTR 830-4G and CCTR-800G on JT808, and a long run of other CCTR numbers on a separate Carscop protocol. Match your label exactly, including any G or 4G suffix, before you configure anything.
Yes, when your variant is on H02: Traxelio runs an H02 listener, and the server address to give the tracker is gps.traxelio.com. Add the IMEI in Traxelio, then watch for the first position. If your variant is a JT808 or Carscop-protocol model, contact Traxelio support first so the right port is confirmed for your unit.
Use the commands in the manual that shipped with your unit. Traxelio has no verified SMS command list for the CCTR, and commands written for other makers may not apply. If the tracker does not answer an SMS, send Traxelio support a photo of the label and ask for the right commands.
The likely reason is the shared H02 protocol, though no source states it. A public device list files the CCTR under Carscop and the SinoTrack ST-901 under SinoTrack, so a shared protocol, not a shared maker, is the link. SinoTrack's app and SMS guides may not match this unit.
Work through these checks: does the SIM have data and credit, does the APN match the carrier, does the port match the protocol your variant uses, and has the tracker had a clear GPS fix outdoors? Then confirm the IMEI entered in Traxelio matches the label on the unit.
Overview
CCTR is a Carscop marking, and the suffix after it matters. A public device list shows the plain CCTR on the H02 protocol, together with CCTR-630, CCTR-830G and CCTR-622G. It lists CCTR 830-4G and CCTR-800G on JT808, and units such as CCTR-620, CCTR-800 and CCTR-831 under a separate Carscop protocol. Traxelio runs an H02 listener, so a CCTR that reports H02 can be pointed at gps.traxelio.com. For a JT808 or Carscop-protocol variant, ask Traxelio support to confirm the setup before you change the server. Rely on the label and the manual that came with your unit for specifications and commands.
About SinoTrack
Keep your SinoTrack tracker and point the ST-901 at Traxelio with an SMS server command. Check your model first: the ST-901 reports over H02 on port 5013, while the ST-901 A+ and ST-902W use JT808 on port 5015.
Speaks the H02 Protocol (Sinotrack / Cantrack family) protocol. Read the protocol reference →
This catalogue entry is associated with H02. Hardware details and configuration instructions for CCTR-630 or CCTR-830G are not established for the unsuffixed CCTR entry.
Technical Specs
| Brand | SinoTrack |
| Protocol | H02 Protocol (Sinotrack / Cantrack family) |
| Status | Compatible |
| Data Points | 10 |
| Supported Alerts | 16+ |
| Compatible Vehicles | |
| Setup | Start setup → |
Data Collected
Your tracker sends 10 data points with every position update, giving you complete visibility.
Live latitude and longitude coordinates updated every few seconds.
Current vehicle speed in km/h, used for speed alerts and driving analysis.
Elevation above sea level, useful for terrain and route analysis.
Direction of travel in degrees, shown as compass bearing on the map.
Reverse-geocoded street address for every position update.
GPS signal precision in meters, indicating location reliability.
Engine on/off status detected via the vehicle wiring harness.
Cumulative distance traveled, used for mileage reports and maintenance.
Total engine running time, key for service interval tracking.
Device or vehicle battery voltage to detect low-power conditions.
Data availability depends on device configuration and installation type.
Detectable Events
Receive 16+ live alerts from your CCTR via push notification, email, or WhatsApp.
The device is back online and transmitting data.
The device has stopped reporting. It may have lost connection or power.
The vehicle is currently in motion.
The vehicle is stationary.
The vehicle is exceeding the set speed limit.
The vehicle has entered a defined zone.
The vehicle has exited a defined zone.
Possible towing activity detected, check vehicle status.
The ignition is ON. The engine has started.
The ignition is OFF. The engine has been stopped.
The vehicle has been idling for a long period.
Hard braking detected, driver safety alert.
Rapid acceleration detected, driving behavior alert.
Sharp turning detected, driving behavior alert.
Potential impact detected based on sudden deceleration and course change pattern.
Key Benefits
See all your vehicles on a live map
Accurate mileage and trip history for billing and disputes
Immobilizer requests for compatible installations
Know instantly when vehicles cross designated zones
Track speeding, harsh braking, and risky driving
Get alerts when vehicles move outside working hours
Identify fuel waste from idling and inefficient routes
Get reminders before breakdowns happen
Plan optimal routes and increase deliveries per day
Control who can see and manage which vehicles
Enter the tracker IMEI first, then verify your email and continue setup.
Setup
Setup guidance
gps.traxelio.com:5013
Public setup commands are available on the protocol guide for this command family.
APN commands depend on the carrier SIM in your tracker, so they are not shown here.
View protocol setup guideSetup guidance
Enter the tracker IMEI first, then verify your email and continue setup.
SinoTrack PRO is listed on the App Store. Traxelio brings every vehicle into one account, with geofences, alerts and trip history.
SinoTrack
FAQ
Common questions about using the CCTR with Traxelio
Start setup yourself, with help available when you need it.
Availability
Connect a tracker you already own, or add a vehicle.