RS485 fuel-level sensor
Tank telemetry on RS485 bus
SKU: LLS-RS485
Server address
Send positions to this server
The Teltonika FMB125 is a 2G/3G fleet terminal on Codec 8 port 5027 · RS232/RS485 fuel sensors, dual SIM, and RFID iButton provision through Teltonika Configurator, then Traxelio plots live fuel curves, trips, and confirmed relay cut on GSM networks across Senegal and West Africa.
Data Points
Alerts
Vehicle Types
Where 2G/3G is stable and LTE Cat 1 modems add cost without coverage gain · common in Senegal today. Plan FMC125 when you need Orange LTE bands or a 2G sunset migration path.
Teltonika Codec 8 on TCP port 5027 · set server IP and 5027 in Configurator. Do not use GT06 port 5023 or h02 port 5013 listeners.
Yes on RS232 or RS485 · match baud in Configurator, calibrate the tank profile, and Traxelio plots live level with trip history.
Yes · primary Orange SN with backup Free SN or a Mali/CIV SIM auto-switches after the Configurator timeout. Single-city Dakar fleets rarely need slot two.
Overview
The Teltonika FMB125 is a hardwired 2G/3G advanced fleet terminal with RS232 and RS485 fuel interfaces, dual SIM failover, RFID iButton, and tachograph support. It streams Codec 8 AVL to port 5027 and is configured through Teltonika Configurator, not SMS PIN commands.
About Teltonika
Lithuanian fleet-grade GPS hardware (FMB, FMC, FMM families) shipped to 150+ countries, the de-facto European standard for commercial vehicles.
Speaks the Teltonika Codec 8 Protocol protocol. Read the protocol reference →
Works with Traxelio · connect it yourself
Verify your email, then add the tracker details on the next screen.
Technical Specs
| Brand | Teltonika |
| Protocol | Teltonika Codec 8 Protocol |
| Status | Compatible |
| Data Points | 12 |
| Supported Alerts | 17+ |
| Compatible Vehicles |
Car
Motorcycle
Pick up
Truck
Bus
Fuel Tank
|
| Setup | Start setup → |
| Network | 2G, 3G |
| GNSS | GPS, GLONASS, Galileo, BeiDou |
| Voltage range | 10-30V |
| Battery | 170 mAh |
| IP rating | IP41 |
| Operating temperature | -40 to +85 °C |
| Dimensions | 79x69x23 mm |
| Weight | 92 g |
| CAN bus | CAN adapter compatible |
| MPN | FMB125 |
Tank telemetry on RS485 bus
SKU: LLS-RS485
Driver identification
SKU: DS1990A
Digital output cut wiring
SKU: REL-5P-12V
Certified
Data Collected
Your tracker sends 12 data points with every position update, giving you complete visibility.
Live latitude and longitude coordinates updated every few seconds.
Current vehicle speed in km/h, used for speed alerts and driving analysis.
Elevation above sea level, useful for terrain and route analysis.
Direction of travel in degrees, shown as compass bearing on the map.
Reverse-geocoded street address for every position update.
GPS signal precision in meters, indicating location reliability.
Engine on/off status detected via the vehicle wiring harness.
Cumulative distance traveled, used for mileage reports and maintenance.
Total engine running time, key for service interval tracking.
Device or vehicle battery voltage to detect low-power conditions.
Fuel tank level percentage, used for refill detection and consumption reports.
Cell tower and signal strength data for connectivity diagnostics.
Data availability depends on device configuration and installation type.
Detectable Events
Receive 17+ live alerts from your FMB125 via push notification, email, or WhatsApp.
The device is back online and transmitting data.
The device has stopped reporting. It may have lost connection or power.
The vehicle is currently in motion.
The vehicle is stationary.
The vehicle is exceeding the set speed limit.
The vehicle has entered a defined zone.
The vehicle has exited a defined zone.
Possible towing activity detected, check vehicle status.
The ignition is ON. The engine has started.
The ignition is OFF. The engine has been stopped.
The vehicle has been idling for a long period.
Hard braking detected, driver safety alert.
Rapid acceleration detected, driving behavior alert.
Sharp turning detected, driving behavior alert.
Potential impact detected based on sudden deceleration and course change pattern.
A fuel refill was detected.
Key Benefits
See all your vehicles on a live map
Accurate mileage and trip history for billing and disputes
Controlled immobilizer support for compatible installations
Know instantly when vehicles cross designated zones
Track speeding, harsh braking, and risky driving
Get alerts when vehicles move outside working hours
Identify fuel waste from idling and inefficient routes
Get reminders before breakdowns happen
Plan optimal routes and increase deliveries per day
Control who can see and manage which vehicles
Enter the tracker IMEI first, then verify your email and continue setup.
Setup
Setup guidance
gps.traxelio.com:5027
Public setup commands are available on the protocol guide for this command family.
APN commands depend on the carrier SIM in your tracker, so they are not shown here.
View protocol setup guideSetup guidance
Enter the tracker IMEI first, then verify your email and continue setup.
Desktop Teltonika Configurator for APN and server setup · FMBT Android app for BLE status on FMB125.
Pricing
You need the tracker and Traxelio together.
Hardware
$75.00 – $110.00
Catalogue band, not store price
Traxelio
17 USD – 29 USD/mo
From 17 USD/mo
Essential GPS tracking with live location, controlled immobilizer action for compatible installations, geofencing, and trip history.
Wrong baud or polling interval is the usual cause · Omnicomm defaults 19200, Eurosens 9600. Re-run LLS calibration in Configurator after wiring changes.
Both slots need active data plans. Default switch threshold is ten minutes without signal · adjustable in Configurator. Update firmware if an early revision ignores slot two.
Wire the reader to 1-Wire, not RS232, and select the iButton profile in Configurator. Some harness batches need the 1-Wire jumper enabled before Traxelio sees driver events.
Teltonika
Teltonika
Teltonika
Teltonika
Teltonika
Alternatives
FAQ
Common questions about using the FMB125 with Traxelio
Start setup yourself, with help available when you need it.